Buyers searching for an XKB fingertip thumbwheel joystick usually need fine hoist inching on a bridge or gantry console — not a full multi-axis palm grip like crane AT16. Trunsin XKB pairs with WK04 thumbwheel modules when the operator must creep wire rope without swinging the main stick through a large deadband [Source: Trunsin XKB / WK04 product PDFs; hoist console RFQ themes on bridge-crane pulpits].
Cross-link hoist joystick controller, port container crane industrial joystick, AT16 multi-axis guide, and crane operator chair joystick when the RFQ mixes fingertip and primary axes.
XKB fingertip thumbwheel joystick — when it beats a full stick
| Console need | Better fit | Risk if mismatched |
|---|---|---|
| Hoist fine inching / micro-creep | XKB + thumbwheel | Overshoot with large-travel palm grip |
| Bridge/trolley primary travel | AT16 / AT20 multi-axis | Finger fatigue on long shifts |
| Auxiliary drum / grab close | Thumbwheel or NE switch | Wrong axis mapped to primary stick |
| Chair armrest dual sticks | Palm grips + optional XKB | Crowded panel without clear hierarchy |
An XKB fingertip thumbwheel joystick RFQ that only says “crane joystick” often returns an AT16 quote the buyer cannot mount on a pendant or compact hoist desk [Source: Trunsin configurator RFQ fields; bridge-crane panel layouts].
Spec checklist for hoist fingertip RFQs
- Travel and return — Spring-to-center vs friction hold for the fingertip axis.
- Thumbwheel function — Analog proportion or stepped contacts for hoist creep.
- Mounting envelope — Panel cutout vs chair armrest vs pendant face.
- Output family — Contact, voltage, or CAN — match the hoist drive ICD.
- IP and seal — Dust on open pulpits vs sealed outdoor gantries.
When the same cab also needs radio backup, see radio remote crane joystick pairing and Scanreco G2 RC400 pairing — fingertip sticks and transmitters are separate BOM lines.
Sales language that prevents wrong quotes
Ask the buyer: “Is this the main travel stick or the hoist fine control?” If they answer fine control, lead with XKB/WK04 photos and panel depth — not a Gessmann-style multi-axis aftermarket path. If they answer main travel, keep AT16 Gessmann V6 replacement in the pack.
Frequently asked questions
Is XKB a drop-in for AT16?
No — fingertip controllers serve different envelopes and operator loads than multi-axis palm grips.
Do I need WK04 with every XKB?
Only when the hoist or auxiliary function needs a thumbwheel; RFQ the axis list first.
Can XKB ship CANopen?
Confirm output on the RFQ — many hoist desks stay on contacts or analog.
Where do I configure Trunsin options?
Use the configurator after panel photos and function map.
Related articles
- Hoist joystick controller
- AT16 multi-axis industrial joystick guide
- Port container crane industrial joystick
- Crane operator chair joystick
- Industrial joystick hub
- Configurator
Specify fingertip paths on XKB and WK04; keep primary axes on AT16 via the Trunsin configurator.